960P Adhesive PU Gun Foam

Akfix 960P is a polyurethane adhesive foam designed for bonding and fixing rigid insulation boards — EPS, XPS, and mineral wool — to walls, ceilings, and floors. It's a go-to solution for insulation contractors and builders who need a fast, reliable alternative to notched-trowel adhesives. The foam also works well for securing window sills, skirting boards, and lightweight construction panels.

Properties

• Powerful adhesion of polystyrene heat panels (XPS and EPS).
• Wall plugging within two hours.
• More economical. Ready to use in an aerosol can.
• Up to 14 m2 heat insulation panel adhesion for each can.
• Minimum expansion during the drying period.
• After drying, no further expansion or shrinkage.
• A lighter material compared to plaster, an alternative material, is used in heat insulation systems.
• No more extra burden or weight to building.
• High yield up to 55 liters, depending on the humidity and temperature.
• Usable at low temperatures like 0 °C
• It does not contain any propellant gases, which are harmful to the ozone layer.

Application Areas

• Best for mounting heat insulation panels and filling voids during adhesive application.
• Advised on wooden type construction materials, concrete, metal, etc.
• Applications needed a minimum expansion.
• Mounting and isolation for frames of windows and doors

For best results, make sure surfaces are clean, dry, and free of dust or grease — a light mist of water on the substrate can speed up curing. Apply the foam in strips or dots directly from the gun, press the panel firmly into place, and hold or brace it for a few minutes until the foam sets. Avoid applying too thick a layer, as the foam expands and can cause panels to bow if over-applied.